Writing VIN on Buick Delphi MT60 ECM Using OBDSTAR DC706

To write the VIN on a Buick Delphi MT60 ECM using the OBDSTAR DC706 ECU tool, follow these structured steps:

Required Tools:

OBDSTAR DC706 (or X300 Classic G3)

High-power DC regulated power supply

Main cable

ECU clone jumper

MP001 programmer

Delphi MT60 ECM

Preparation:

Ensure the software is updated to the latest version before starting.

Steps to Write VIN:

1. Access ECU Flasher

Tap [ECU Flasher] > [ECM] > [ECM V31.70].

Use the search function in the upper-right corner to locate the module quickly.

2. Review Guide & Connection Methods

Tap [Guide] and carefully read the operation instructions.

Review the procedures for both the BOOT and BENCH modes.

3. Select and Verify Connection Mode

Open [Pinout], select [BENCH], and confirm the module's appearance matches your ECU.

Open [Connector Pinout] and follow the connection diagram.

4. Establish Connection

Connect the module accordingly.

Tap [Start] to begin.

Note: If cloning the ECU, use the BOOT mode instead.

5. Backup Original Data

After a successful connection, back up the original ECU data.

Customize the file name as needed.

6. Write the VIN

Tap [Write VIN].

Enter the new VIN.

Confirm the update. Writing completed!

Conclusion:

By following these steps, you can efficiently modify the VIN on the Delphi MT60 ECM using OBDSTAR DC706. Always ensure data backup before making changes.

Video guides:

www.obd2shop.co.uk